August 17, 2019 – In order to continue the exterior wall repair and framing for the new sliding door it is necessary to do a little electric upgrade and relocation. Near the front door we have two switches. One controls the overhead living room lights and the other controls an outside light. We can remove the outside light but the overhead light switch needs relocated.
Originally there was a 30 amp fuse box to power the entire cottage. I upgraded the 30 amp fuse box to a 100 amp panel way back in 2004. When the old fuse box was in service there was a circuit for the well pump, a circuit for the electric range and only three other circuits to power the remainder of the cottage. I knew at that point that an electric upgrade and complete rewiring was in our future.
The cottage was wired back in the 1950’s with two conductor cloth covered wire. In this type of wiring there is a hot wire and a neutral wire but no ground wire. There are numerous junction boxes in the ceiling. In some of these, the connections are soldered and covered with fabric based electrical tape. In others the connections have wire nuts. Some of the wire looks like there is burn marks on the outside of the insulation.
After spending most of the day up in the attic I figured out the routing of one of the circuits and I was able to begin replacing old wire. I relocated the overhead light switch and added a new outlet by the front door. I was also able to replace the “toaster” outlet wire that Fanny used to blow the circuit breaker on. That one had some serious burn marks. It’s a wonder we haven’t burned the place down!
The electric upgrade is well underway!
Tomorrow when my Demo Crew arrives we will continue the demolition on the exterior wall. In addition I am hoping to finish the Trex decking installation in the last section of deck, i.e. “Brenda’s Deck”.