October 12, 2019 – Yesterday I completed the remaining posts and edge beams. Today the framing at the porch roof section three can begin in earnest.
The first order of business is cutting off the old oak rafter tails. On the last rafter tail there is a motion activated spot light. Installed by one of Fanny’s friends decades ago, I can’t remember the last time it actually worked. I had to climb up into the attic and crawl back to the back bedroom to disconnect the wiring. The color and the light coming through the cracks in the roof decking made for a surreal look inside the attic.
Ceiling Joists – Porch Roof Section Three
With the rafter tails and spot light removed I started install the ceiling joists in porch roof section three. Each of the three porch roof sections contains about twelve ceiling joists and twelve rafters. Coincidentally, it takes twelve sheets of plywood to cover a section.
Immediately after ceiling joists comes the installation of the solid bridging. If you are following this blog, you will note that this process is repetitive. I have written about ceiling joists and solid bridging at least two times before. The great thing is that this is the last section so I won’t have to bore you anymore.
Near the end of the day I finished up the solid bridging. After checking the blue tarps to make sure that we were good if it rains, I headed into town to grab a bite to eat. Downtown OIP & Grille, it is a pizza and beer kind of night!
Tomorrow I’ll start the first span of rafters in the porch roof section three. See you then!